You may have a problem with the freeze plug on the lower part of your engine block. If it is leaking, a big piece of card board placed under your car beneath the engine will show spots from engine coolant. If all of the coolant seems to hit the same spot, take your car to a mechanic and have it checked with the car up on a rack. This is the best way to access the freeze plug and replace it.
The main purpose of recycling these materials is to protect human health and the environment. Throwing used oil in the trash, dumping it on the ground or into a lake, river or storm drain poses a threat to every living organism it contaminates. One gallon of improperly disposed motor oil can pollute 1 million gallons of drinking water which is enough to supply 50 people for one full year! One pint of oil can cause a one acre oil slick. Used motor oil contains heavy metals and it is insoluble, and it doesn't take much to pose a threat. Let's clean up our act in 2010 and make our environment a safer place.
Shine up the paint: Embarrassed by nicks and scratches on your car? Buy some touchup paint from a dealer or auto store near me. Wash the car thoroughly, then paint over the nicks. Once the paint dries, coat your car with high-quality wax or polymer finish to bring back the shine.
You Maintain Your Peace Of Mind: At a typical brick 'n' mortar store, some salespeople might seem to act pushy at times, and it can very disturbing. closest advance auto parts to me saves you the trouble of dealings of such an undesirable experience.
Your local auto parts store near me should be able to easily determine which oil filter you need, as well as what grade of oil will be best. Discuss this with them and make sure you have handy your 'make, model, and year of vehicle'. Using this information, the service attendant on duty can assist you in getting the proper parts and oil.
While holding the sachet vertical, slowly dribble the adhesive into the edge of the bolt hole as shown, ensuring that the adhesive flows into the joint between the seat rail and the zinc block. DO NOT pour the adhesive down the center of the hole. The object is to let the adhesive "wick" between the zinc block and the seat rail in order to bond the two pieces together.
You want to use a thinner grade of oil when it is cold out. If you use a single grade of oil you should replace the oil with a winter grade. You may not need to make this adjustment if the type of oil you are using is a multi-grade oil. Check with your car dealer or with your mechanic or auto parts near me. They can tell you if you should make the change.
You need something to drain your oil into, a slender short pan will usually work the best. Some vehicles may need to be jacked up at this point, while others may not. If you can gain easy access to the bolt in the center of the oil pan, and place your oil catching pan underneath your vehicle, you may skip jacking it up off the ground.